Bombardier SeaDoo 1992 factory shop manual, Page 234Get this manual
Battery Refer to BATTERY 07-03 then look for removal to remove and clean the batteryApply some dielectric grease (PIN 293 550 004) or petroleum jellly on battery posts and all exposed cable connectorsAdd distilled water if necessary then give the battery full charge at maximum rate of two amperesRefer to BATTERY 07-03 then look for chargingStore the battery on wood shelf in warm dry place away from direct sunlight
Disconnect hoses where shown
Disconnect
To prevent battery sulphating and discharging, have it charged every month
Anticorrosion Treatment
Wipe off any residual water in the engine compartmenltSpray SEA-DO0 LUBE over all metallic components in engine compartmentpincher here
FWI 004 013 .1Water inlet hose
Additional Recommended Protection1
Cooling system may be filled with 50 50 water antifreeze solutionCAUTIIONAlways use ethylene-gllycol antifreeze containingcorrosion inhibitors specifically recommended for aluminum enginesNOTEThe engine will not have to run during this operationThree hoses have to be disconnected to allow air to escape and antifreeze solution to completely fill cooling systern water jackets Install hose pincher on water injection hose