Bombardier SeaDoo 1992 factory shop manual, Page 232Get this manual
Section STORAGE 1
Or if equipped with flush kit, remove dust cap from tee fitting spigot of flush kit and attach coupler hose Make sure coupler hose is properily locked to tee fitting spigot
CAUTIONNever flush hot engineAlways start the engine before opening the water tapOtherwise, water will back flow through the tuned pipe into the engine and may cause damage to internal partsOpen water tap immediately after engine is started to prevent overheatingFollow this procedure exactly
5Run the engine about five minutes at fast idle around 3500 RPM
Tee fitting spigot
CAUTIONNever run engine longer than five minutesDrive line seal has no cooling when watercraft is out of water6Remove plug from flame arrester coverFlame arrester ve r