Bombardier SeaDoo 1992 factory shop manual, Page 228Get this manual
Section 10 HlJLLjBODY Sub-Section 01 BODY]
CONCEPTTM PAlNTING PROCEDURE
INSTRUCTIONS FOR SPOT!PANEL AND OVERALL JIOBS
For additional information refer to PPG P-Buiietin no168
FULL PAINEL AND OVERALL REPAIRS
,Prepare and clean surface consistent with good painting practicesPrimer DP Epoxy Primer DIP 401 Catalyst; DX 17911792 (Prime before topcoating)'Primer Surfacer K36IK201, K2001K201 or IQZ KONQARm Primer SurfacersNCITEKONDAR must be sealed before applying CONCEPT colorSealer KTS30 2K Sealer, DP Epoxy Primer reduced as sealer or DAS 1980 or DAS 1987Application Apply one medium wet coat and glve 5-10 minultes flash followed by two wet coats with 15 minutes fllash time between each coatAdjust metallic on the last full wet coat, If necessary, apply mist coatFor medium solids optonl apply two full wet coatsAir Pressure 40-50 lbsalt-the-gun Dry TimeDust free30 minutes- Tackfreetwo to three hours- Tape print free six hours:Dry to handlesix to eight hours at 70 (2l0C.I