Bombardier SeaDoo 1992 factory shop manual, Page 222Get this manual
Section 10 HULLBODY Sub-section 01 (HULLBODY 1-
CAUTION :Allow at beast 30 minutes for primer cureApply Sikaflex sealant 221293 530 011) oln water tank trap and slide it back to its positionSikaflex primer 449 andSikaflex sealant 221
Install brackets (PN 291 000 2131 to support the rear section of tank and secure them with M6 stainless screws (PIN 210 000 004) and lock nuts 212 000 0011Brackets i
Bracket A
Tow hook
Install fuel tank and storage coverTo install engine, refer to ENGINE 03-02 then llook for installationInstall jet pump unit ass'y, refer to PROPULS!ON AND DRIVE SYSTEMS 08-01 then look for installationVerify tightness of all fuel lines and clamps and pressurize fuel systemFor pressurization procedure refer to FUEL SYSTEM 05-03WARNINGIf any leak is found do not start the engine and correct the leakFailure correct leak could lead an explosionIf any fuel spilllage andor leak had occurred the bilge should be cleaned with hot water and detergent or bilge cleaner remove fuel dlepositsBefore using watercraft wait three days for Sikaflex curing time