Bombardier SeaDoo 1992 factory shop manual, Page 207Get this manual
Section 08 PROPULSION AND DRIVE SYSTElMS Sub-section 03TRIM SYSTEM (VTS))
15,22, Set Screw and Spring Washer
Remove set screw from the end of worm then slide off flatwasher and spring washers
ASSEMBLY
Assembly is essentially the reverse of disassembly proceduresHowever pay particular attention to the following
13,16, Worm and Sliding Collalr
Whenever replacing either worm or sliding collar, install set screw which acts as stopper for the sliding collar
NOTEAlways lubricate worm with synthetic grease (PIIN 293 550 0101
22, Spring washer
Installll middle spring washers the way their inside dlarneters are touching each other Install outside spring washers the way their outside diameters are contacting housing and flat washer