Bombardier SeaDoo 1992 factory shop manual, Page 197Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS)
Make sure rubber damper is on drive shaft endCAUTIOIN:Some watercraft have shim between hull and pump, if shim has been removed ensure reinstall itIf not install, engine and jet pump alignment will be altered
- Insert pointed tilps of
pliers first in closing hooks
Insert drive shaft end through hull tunnelSlide through seal carrier being careful not to damage sealsPush on pump until shaft comes close to PTO flywheelCAUTION :When sliding the drive shaft through seal carrier, the double tip seal (PN 293 200 0091 could be folded overThis could cause seal carrier bearing failureWhile holding pump, guide and engage shaft splines in PTO flywheelRotate shaft to properly index splinesMake sure boot is well positioned over shaft end
If necessary, tap pump end with rubber hammer until retaining nuts and washers can be installedApply Inctite 242 (blue) 293 800 015) on threads and equally tighten nuts in criss-cross sequence and torque to 35 Nm (26 lbfft