Bombardier SeaDoo 1992 factory shop manual, Page 193Get this manual
Section 08 PROPULSIOIN AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS)
CAUTIONThis is synthetic oilDo not mix with mineral based oil,Do not mix oil brands
2,15, Fitting
Apply Loctite PST 592293 800 018) on plastic fitting threadsThen thread fittings into pump housing until threads are bottomed
NOTEWhen filling, oil must be poured into cover quite slowly to allow complete housing fill
Pour oil slowly until it flows out of hole
Slide new boot on drive shaftTo ease installation, apply some liquid soap on outer circumference of boot
Apply Loctite PST 592293 800 018) on plug then secure on cover
Clean drive shaft splines with Loctite solvent 755293 800 019)Free splines from any residue Allow solvent to dry thoroughlyGenerously apply synthetic grease293 550 0101 on drive shaft splines and impeller splines Make sure rubber damper is on drive shaft end Insert drive shaft in impeller then carefully insert boot in impeller Use blade of screwdriver to push on boot