Bombardier SeaDoo 1992 factory shop manual, Page 192Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (lPROPULSION AND DRIVE SYSTEMS)- Torque impeller to 70 Nm (52 lbfft) then remove toolsCAUTION :Never use anyimpact wrench to tighten impeller[PIN 295 000 001)
lmpellerremover
PUMP PRESSURIZATION
Whenever doing any type of repair on the pump, pressure test should be done to check for any leakagePressure Test Proceed as follows- Remove plug from housing coverDrain oil- Apply Loctite PST 592293 800 0118) on threads fitting (PIN 295 000 086) then secure on cover
- Connect pump gauge tester295 000 083) to
Impeller holder295 000 0821
fitting- Pressurize pump to maximum of 70 kPa (10 PSI)Pump must maintain this pressure for 10 minutes
11,13,18, O-ring, Housing Cover, Loctite 515
Apply Loctite 515IN 293 800 007) on 101-ring and install on housing cover then carefully insert cover on impeller housing making sure to properly position plug on top side