Bombardier SeaDoo 1992 factory shop manual, Page 183Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION ANID DRIVE SYSTEMS)
4, Needlie Bearing
Pulling seal out of housing
NOTE: It is always recommended to renew both bearings, even if only one needs to be replacedBearings can be easiily removed with the following suggested pusherUse 30 mm diax 345 mm long (1-118 diax 13-112 in) steel shaftMachine shaft as per the following drawing
865 in) dia
28 mm 11 115 in) dia
Or, use Snap-on hammer puller includingHandle CJ93-1 Hammer CJ125-6 Claws CJ93-4