Bombardier SeaDoo 1992 factory shop manual, Page 181Get this manual
Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS)
NOTEjammed drive shaft can be removed by holding pump unit by drive shaft, slightly raised above smooth surface, then striking all around of impeller housing with fiber hammerCorroded parts can be loosened by applying penetrating oil such as SEA-DO0 LUBE293 600 0061
13,14, Holusing Cover and Screw
Starting with pump assembly in horizontal position, remove three retaining screwsPlace container under cover to catch oilUsing fiber hammer, gently tap cover to release from impelller housingInsert impeller shaft holder (Pf 295 000 082) on flat end of impelller shaftUsing two screws previously removed from venturi, secure shaft holder to housingTo ease removal heat impeller center with propane torch to approximately 150 (300QRto break the Loctite bondImpeller is loosen using impeller remover (PN 295 000