Bombardier SeaDoo 1992 factory shop manual, Page 177Get this manual
Section 08 PROPULSION AND DRIVIE SYSTEMS Sub-Section 01 (PROPULSION AND DRIVE SYSTEMS)
- Use threaded rod 13 170 rnm (12 N.Cx 6-12 in)
longOn one end install 13 mm (12 in) diameter nut flush with the end and weld it- Weld two cold rolled rods 10 180 mrn
Drill 16 rnm (51 dia hole
(38 in) long on the nut as shown in the following illustration
(112 welded
38 mm (1-112 in)
8 mrn (21164 l
dia hole
- Ilnstall two 16 mrn (518 in1 washers on threaded rod
before final assembly
- Glue rubber mat or similar protective material on support to prevent scratching hull rear section,
- Use one steel flat bar 38 13 rnm (1-12 12 in) thick 115 mm (4-112 in) long or two flat bars mrn I114