Bombardier SeaDoo 1992 factory shop manual, Page 161Get this manual
Sub-section 06
Section 07 ELECTRICAL (CDI AND CHARGING SYSTEMS)
Magneto and Generating Coil Output
1Disconnect BLACKiRED wire between ignition coil
Ignition Coil Output
A paper clip of approximately 20 mm (34 in) will be used as test adapter for the following test1Install the test adapter to spark plug cable close to MAG side spark plug2Connect tester wires then set switch and dial as follows :
Cornponent wires Tester switch position
CD1 module and magnetoDisconnect BLACK ground wire2Connect tester wires then set switch and dial as followsNOTEBLACK wire must be connected to ground in order to start engineTaster wires Component wires
s switch position Tester dIid position
Tester adapter (paper clip) on spark plug cable
BLACK RED of magneto harness