Bombardier SeaDoo 1992 factory shop manual, Page 147Get this manual
Section EILECTRICAL Sub-section 04 (ELECTRIC STARTER)
Solenoid Switch
Inspect connections and clean as necessarySolenoid switch condition can be checked with an ohmmeterInstall test probes on large connectors of solenoidMeasure resistance when current is applied to small connectors+12 on YELLOWRED wire and negative- on BLACKIWHITE wireIf it is more than few ohmsreplace solenoid switchIMPORTANT: No current must be present on large cables when using ohmmeter, otherwise meter could be damaged
5,10, Housingand Yoke Assty
Align previously traced indexing marks
Align marks
ASSEMBLY
Reverse the order of disassembly to reassemble starterHowever, attention should be paid to the following operationsPrior to assembling, coat sliding surfaces on armature shaft splines, overrunning clutch and bushing with 6.EVersilube 341 or ESSO Beacon 325 lubricant or equivalentApply motor oil on metal bushings