Bombardier SeaDoo 1992 factory shop manual, Page 133Get this manual
Section 07
ELECTRICAL Sub-section 02 (IGNITION TIIMINGI
- Loosen adaptor lock nut then holding gauge with dial
facing toward PTO, screw adaptor in1 spark plug hole
- Slide gaugle far enough into adaptor to obtain ireadlng then finger tighten adaptor lock nut- Rotate PTO $lywheel counerclockwise until piston is
NOTE liming lllght is balttery powered (two batteiries, tyipe and therefore needs no auxilary power source
at Top Dead Center
- Unlock outelr ring of dial and turn it until zero
The ignition components are affected by temperature must be checked when enmiatton, therefore, trnlng gine is cold, after MAXIMUM 20 seconds idlng
dtal aligns with pointer- Lock outer ring in position
1Connect timing light pck-up MAG sidle spark plug to lead
5From this point, rotate flywheel back 114 turn then rotate it counerclockwse reach 2.65 mm 4.104 in1 to