Bombardier SeaDoo 1992 factory shop manual, Page 114Get this manual
FUEL SYSTEM03 (CARBURETORS)
Section 05
NOTEGrease carburetor linkage at both ends with synthetic grease (PIN 293 550 010)Connect linkage between both carburetors and fully tighten Allen screws on carburetor throttle llever MAG side Be careful not to rotate lever while tightening t
CAUTION :This set-up is done ensure good synchronization between carburetor throttle levers when throttle lever is pushed at handlebar grip
10,12, Fuel Sensor and Fuel Sensor Aldapter
WARNING :Always disconnect battery cables exactly in the specified order, black negative cable firstElectrolyte or fuel vapors can be present in the engine compartment and spark might ignite them and possibly cause personal ilnjuriesDisconnect the red positive calble lastEmpty fuel tankWARNINGFuel is flammable and explosive under certain conditionsAlways work in well ventilated areaDo not smoke or allow open flamesor sparks in the vicinityAlways wipe off fuel spillage from the watercraftRemove storage basket from watercraft
GTX Model (5860) o
Unhook fuel tank strap slide it off through tie rap behind vent tubePress on vent tube upper part to enable to withdraw tube from bodyF001 005 041