Bombardier SeaDoo 1992 factory shop manual, Page 101Get this manual
Section 04 COOLING SYSTEM Sub-section 03 (FLUSHING AND CARE)
5For hose clamp installation, use special pliers 295 000 07016Wheninstalling hoses onto fittings or when troubleshootingfor water intake in the bilge area, confirm that all hoses are properly tightly secured to the fittings7Check overheating beeper operation by jumping terminal of thermosensor wire to ground Beeper must operate
NOTE: Engine has to be started to test beeper operationAt every verification of overheating beeper always apply dielectric grease (PIN 293 550 004) on thermosensor connectorVerify wire terminal on connector for tightnessIf too loose, squeeze terminal slightly at installationCAUTIONWhen investigating for no water flow in the cooling system, check alll elbows and straight fittings as well as all hoses for blockage