Bombardier SeaDoo 1992 factory shop manual, Page 62Get this manual
Section 03 ENGINE Sub-section 03 (TOP END)
17,18,19, Screw, Glrease and Cylinder
Apply synthetic grease (PIN 293 550 010below screw head Apply Loctite 242293 800 01 5) on screw threadsInstall and torque screws in criss-cross sequence for each cylinder to Nm (17 lbf-ft)
Torque screws to 24 Nrn (17 Ibfftl
Make sure to install1 large O-rings around spark plugs holes and small O-ring where shownLarge O-rings
1,4,6, Screw andrHead Cover
Torque screws to 24 Nm (17 Ibft)
F001 003 113
Installl cover over cylinder headApply Loctite 242 (PIN 293 800 015) on screw threadsThe two longer screws must be installed on oval-shaped housingMake sure to install flame arrester support