Bombardier SeaDoo 1992 factory shop manual, Page 58Get this manual
Section 03 ENGIINE Sub-section 03 (TOP END)
ASSEMBLY
Assembly is essentially the reverse of disassembly proceduresHowever pay particular attention to the following
23,24,26, Piston, Piston Pin anld Roller
Bearing
At assembly, locate piston so that intake hole is on rotary valve sideCarefully cover crankcase opening as for disassembly Installation of roller bearing and piston pin using proper service too! piston pin puller (PIN 290 877 0901, proceed as follows :
- Replacement bearings are held in place by locating
- Insert piston pin into piston until it comes flush with
inward edge of piston hub- Warm piston to approximately 50-6O0C (122-140F
sleeve outside and two plastic cage halves inside
- Push the inner halves out of the bearing as per following illustration
andinstall it over connecting rod- Insert extractor spindle into the piston pin, screw on