Bombardier SeaDoo 1992 factory shop manual, Page 5Get this manual
This rnanlulal has been prepared as guide to service the SEA-DOO, models SPsao5, XPsssi, GTS 5812 and GTX 5860T1hisedition was primarily published to be used by watercraft mechanics who are already familiarwith all service procedures relating to Bombardier made watercraftPlease note that the instructions will apply only if proper hand tools alnd special service tools are usedThis Shop Manual uses technical terms which may be slightly different from the ones used in Parts CatalogThe content depicts parts andlor procedures applicablet the particular prodluct at its time of manufactureIt does not include dealer modifications, whether authorized or not by Bombardier, after manufacturing the productIn addition, the sole purpose of the illlustrationsphotographs throughout the manual, is to assist identification of the general configuration of the partsThey are not to be interpreted as technical dralwings or exactreplicas of the partsThe use of Bombardier parts is most strongly recommended when considering replacement of any componentDealer andlor distributor assistance should be sought in case of doubtTorque wrench tightening specifications must be strictllly adhered toLocking devices (ex: locking disk, elastic stop nut) must be installed or replaced with new ones, where specifiedIf the efficiency of locking device is impaired, it must be renewed