Bombardier SeaDoo 1990 factory shop manual, Page 177Get this manual
Section STORAGE 1
The following steps should be performed to provide the watercraft enhanced protectionRemove muffler and drain out as much water as possible Reinstall muffler
ORDisconnect one hose from muffler and pour some antifreeze liquid inside mufflerReconnect hose
Lubricate the throttle cable with SEA-DO0 LUBE NOTEcable luber can be used on throttle cable end to power inject SEA-DO0 LUBE into cableRefer to motorcycle parts supplier for availability Clean the bilge with hot water and detergent or with bilge cleanerRinse thoroughly Lift front end of watercraft to completely drain bilgeIf any repairs are needed to body or to the hull, touch up paint such as yellow paint293 500 0081 grey paint293 500 009) and gel coat repair kit 295 500 003) are availableReplace damaged labelsldecals Wash the body with soap and water solution (only use mild detergent) Rinse thoroughly with fresh water Remove marine organisms from the hull Apply nonabrasive wax such as silicon wax Protect the seat with vinyl protectant such as Armor All or the equivalent CAUTIONNever clean apparent fiberglassand plasticparts with strong detergent, degreasing agent, paint thinner, acetone etcIf the watercraft IS to be stored outside, cover it with an opaqluetarpaulin to prevent sun rays and grime affecting the plastic components, watercraft finish as well as preventing dust accumulation