Bombardier SeaDoo 1990 factory shop manual, Page 157Get this manual
Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 02 (REVERSE SYSTEM) 27, Reverse Gate Spring
It is not niecessary to remove reverse gate from venturi housing to replace reverse gaite springsThese springs are installed to ease the upward movement of reverse gate Remove left lower nut holding impeller housing to hull Pull spring and retainlingwasher, then unhook spring from washer-
24, Reverse Gate
Install reverse gate with sleeve and plastic washer Apply Loctite 242N 293 800 015) on threads and torque to 20 (15 lbfmftl
CAUTION :Always hook reverse gate springs in order to get reverse gate easier functioning
Retaining
FOOZ 00s 009
1, Reverse Support Plate
ASSEMBLY
Assembly is essentially the reverse of disassembly procedures However pay particular attention to the following