Bombardier SeaDoo 1990 factory shop manual, Page 149Get this manual
Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) -
CAUTION :This is synthetic oilDo not mix with mineral based oil NOTEWhen filling, oil must be poured into cover quite slowly to allow complete housing fill
Pour oil slowly until flows out of hole
2,15, Fitting
Apply Loctite PST 567 (PIN 293 800 013) on stainless fitting threads and Loctite PST 592293 800 0181 on plastic fitting threads then thread fittings into pump housing until threads are bottomed
27,64, Boot, 0-Ring
Slide new boot and drive shaft To ease inon stallation, apply some liquid soap on outer circumference of boot
Apply Loctite PST 567 293 800 013) on plug then secure on cover
17,20,35, Venturi, Screw0-Riing
Install new O-rings around bailer passages Position ventun with bailer passages on top ApplyLoctite 515 Gasket Eliminator 293 800 0071 on mating surface Apply Locate 242 (blue) 293 800 015) on threads and install screws and washers then torque to 25 (18 lbfft) in criss-cross sequence