Bombardier SeaDoo 1990 factory shop manual, Page 146Get this manual
Sectktn 08 PROPULSIONDRIVE SYSTEMS- Sub-Section 01 (PROPULSIIONDRIVE SYSTEMS)
5ear1ng1 nmpeller side must be1 to mm 060 onI00 in) nslde reservoir measured from seal seat Bear' lng on venturl sde must be '&I mm080120 in1 insde reservoir measured from thrust washer seat Refer to follownnlg illustration
Strike Tool end with halmmer until tool flange ccmtacts housing
Strike on tool IJnt11it stops
t 080120 lr
Thrust washer seat
Stamped end of bearmg
Apply synthetic grease (PIN 293 550 010) between seal lipsSame tool WIII be used to mstall seal
Seal must lbe nnslalled so that raised edges ofare toward outside of 'nousng(toward rnpeller) Apply Loctnte 515 (PIN 293 800 0071 lln seal housng, all around Duter dameterand on seal seat Properly msert seal on tool