Bombardier SeaDoo 1990 factory shop manual, Page 140Get this manual
Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS)
Or, use Snap-On Hammer Puller including Handle CJ93-1 Hammer CJ125-6 Claws CJ93-4
22 mrn865 dia l
28 33 mrn (1115 dia
Close puller claws so thalt they can be inserted between seal and bearing Holding claws, turn puller shaft clockseal wise so that claws open and tighten aganst Slide puller sleeve outwards and gently tap puller end Work with small strikes otherwise claws will shp out As soon as seal begins to slide out, retighten claws to always maintain them tight against seal Continue pulling until seal is out
Insert pusher into one bearing then push tool using arbor press until bearings are out This remover tool may also be used with hammer However, care should be taken not to damage bearing journalsout of housing