Bombardier SeaDoo 1990 factory shop manual, Page 138Get this manual
Section 08 PROPIULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTIEMS)
2,15, Fitting
Fittings can be removed with deep socket or vise gripDo not contact hose mounting areaFitting can be remove from pump housing with following suggested tool
- Use deep socket 14 mm (9116 in)-
Impeller is loosen using impeller remover 295 000 001)
Drill deep socket with 14 mm 1916 in) drill bit, starting at hexagone head end as shown in following illustration Drill one 40 mrn (3132 in) hole in center of deep socket as shown in following illustration Install 40 mm (3132 in) roll pin in the center hole Install shaft holder in viceInsert special tool in impeller splines
42 50 mrn
Rotate counterclockwise and completely unscrew impeller
Impeller remover (P295 000 001)
(1-2964 in)
14 rnrn (9116 in)