Bombardier SeaDoo 1990 factory shop manual, Page 108Get this manual
Section 07 ELECTRICAL Sub-section 04 (MAGNETO SYSTEM)
- Install new receptacle connector to the blackyellow
striped wire- To insta1Il the ground connector to the armature plate,
28, Battery Charging Coil
To replace battery charging coilHeat the armature plate to 150QC (300Faround the screw holes to break the Loctite bond
tape the new black lead to the old one and pull it under the charging coil with the old wire-
Solder an eye connector to the lead and fasten it under the wire retaining clip
Protect harness
Wire retaining clip
A001 002 003
AOOI 002 005
CAUTIONProtect harness from flame- Remove screws- Remove the wire retaining chp from armature platePull out protector tubes and unsolder the splice con-
24,27,Generating CoilScrew
To install the new coil on the armature plate, remove the shipping nuts from the new coil and apply Loctite 242 (blue, medium strength) to screws before assembly