Bombardier SeaDoo 1990 factory shop manual, Page 91Get this manual
Section 06 OIL SYSTEM Sub-section 01 (REPAIRADJUSTMENT)
CHECKING OPERATION
On Watercraft
Bench Test
The oil pump must be removed out of watercraft Connect hose filled with iqection oil to main line fitting Insert other hose end in an injection oil containerUsing counterclockwise (reverse position) rotating drill rotate pump shaft Oil must drip from outer holes while holding lever in fully open position If not replace pump
Main oil line to an oil container
NOTEMain oil line must be full of oil See bleeding procedure above
Unbolt banjo fittings from pump Start engine and stop itsoon as it fires
Check that oil level in small oil lines is passed banjo fitting by about 25 mrn (1 in) (this will be indicated by clerir section of small oil lines of about 25 mrn (1 Ret eat the procedure untd this condition is attained