Bombardier SeaDoo 1989 factory shop manual, Page 129Get this manual
Section 08 PROPUILSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS)
Apply silicone
Apply silicone where indicated by shaded area
No lip on wear ring
Flat edge
a bottom
FOOI 009 072
Prior to installing screws, apply PL-32 Sealant lP 293 800 001) on all screw threads Evenly tighten screws in criss-cross sequence
Make sure rubber damper is on drive shaft endInsert drive shaft end through hull tunnelSlide through1 seal carrier being careful not to damage seals Push on pump until shaft comes close to fllywheel While holding pump, guide and engage shaft splines in flywheel Rotate shaft to properly index splines Make sure boot is well positioned over shaft end
If necessary, tap pump end with rubber hamimer until retaining nuts and washers can be installed Apply Loctite 242 (blue)293 800 002) on threads and equally tighten nuts in criss-cross sequence and torque to 25 Nm (18 IbfftI