Bombardier SeaDoo 1989 factory shop manual, Page 124Get this manual
PROPULSION 81 DRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS)
Section 08
3,4, SealNeedle Bearing
Bearings anld seal will be properly installed in housing using bearing installer tool (PIN 295 000 014)
CAUTIONThis tool has been designed properly position bearings and seal thus, providing space for lubrication purposesThe tool flanges allow for thisIf different pusher type is being used, components must be properly positioned as follows
Bearing on impeller side must be 1.5 to 2.5 mrn 4.060
- 100 in) inside reservoir measulred from seal seatBearing on venturi side must be to mrn (.080.I20 in)
inside reservoir measured from thrust washer seat Refer to following illustration
FOOl 082
060100 in)