Bombardier SeaDoo 1989 factory shop manual, Page 120Get this manual
Section 08 PROPULSION 81 DRIVE SYSTEMS Sub-section 01 (PROPULSIONDRiIVE SYSTEMS)
Remaining silicone can be removed with steel brush (disc) mounted on drill motor22 mrn865 in) dia
28 33 mm (1 115 in) dia
Bombardier stripper #I57 (PIN 295 000 0401 can be used to remove remaining silicone Carefully apply on mating surfaces taking care not to extend outside of this area because paint will be damagedLet product dissolve silicone then scrape itProperly clean all thread's Discard all 0-Rings alnd clean parts in solvent Carefully check water passages (bailer, cooling system) and oil passagesBlow low pressure compressed air through them and make sure they are not clogged
Insert pusher into one bearing then push tool using airbor press until bearings are outThis remover tool may also be used with hammerHowever, care should be taken not to damage bearing journals
Push bearings
FWI 00s 039
Oil passages