Bombardier SeaDoo 1989 factory shop manual, Page 119Get this manual
Section 08 PROPULSIONDRIiVE SYSTEMS Sub-section 01 PROPULSIONDRIVE SYSTEMS!
Or, ulse Snap-On Hammer Puller including
Pushing seal and b'earings out from real
Handle CJ93-1 Hammer CJ125-6 Claws CJ93-4
If only seal needs to be renewed, proceed as follows CAUTIONIt is not recommended to push seal1 out with punchHousing andlor bearing(s1 could be damaged
Close puller claws so that they can be inserted between seal and bearing Holding claws, turn puller shaft clockwise so that claws open and tighten against sealSlide puller sleeve outwards and gently tap pullller endWork with small strikes otherwise claws will slip out As soon as seal begins to slide out, retighten claws to always maintain them tight against seal Continue pulling until seal is out