Bombardier SeaDoo 1989 factory shop manual, Page 115Get this manual
Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 01 (PROPULSIONDRIVE SYSTEMS)
- Weld one spacer
Bailer tubes
13 412 in) thick 25 mrn in) wide approximately 50 mm 12 in) long, each end of each bar on the same side of holesscratching rear end of hull
- Wrap protective tape around each spacer to prevent
SNIDE VIEW
Wrap tape all around
Weld here Coolant inlet hose
F001 009 018
Remove ball joint fasteners to release it from nozzle
21,22,23,24, Screw, Sleeve, BushingNozzle
Manually turn nozzle from side to side; it must pivot easily
Remove nuts retaining impeller housing to hull
NOTETo ease steering operation, inside of nyilon bushings can be slightly enlarged with 13 rnm (112 in) round file (rat tail type)
screws and withdraw nozzleRemove two retaining Push sleeves and bushings out of nozzle