Bombardier SeaDoo 1989 factory shop manual, Page 80Get this manual
Section 06 OIL SYSTEM Subsection 01 (RIEPAIRADJUSTMENT)
ADJUSTMENITS
Synchronization
CAUTION :As oil injection pump adjustment is dependant on throttle cable position, make sur perform throttle cable adjustment firstEliminate throttle cable free-play Ibby depressing throttle lever until slight resistance is felt In this position, marks on pump body and lever must align
Must be full of oil
NOTEmirror may be used to facillitate this verification
If necessary, turn cable nuts to obtain pump mark alignment
Keep flowing until all air has escaped from lineMake sure no air bubbles remain in oil feed line Re-install and tighten bleed screw Wipe any oil spillage Check small oil lines between pump and intake manifoldThey must be full of oilIf not, engine at idle speed while manually holding pump lever in fully open position Do not activate throttle levernuts
CAUTION :Water must be supplied cool engine with flush kit295 000 038
marks ed
$001 003 003