Bombardier SeaDoo 1989 factory shop manual, Page 27Get this manual
Section 03 ENGINE Sub-section 02 (REMOVALINSTALLATION)
Firmly tighten capTo ensure water-tight mounting, pull1 cableit must not slide through grommetRetighten as necessaryTorque cover screws to Nm (71 lbfein k
9,11,12,13,14,30,38, Exhaust Manifold, Screw, SaddleClamp
Position each clamp so that screw will be accessible its from topPosition each saddle so that its higher side is at bottom Install screws paying attentionto their different length with washers and spacers as shown
Torque screws in criss-cross sequence to 20 Nm (15 Ibfft)
1,3,4,5, Nut, Tune Pipe0-Ring