2002 Polaris Freedom, Virage, Genesis PWC Service Manual, Page 213Get this manual
Final DrivePropulsion Intake ScoopRide Plate Removal and InstallationContinued
1Insert inlet scoop into pump cavityApply marine grade silicone to scoopride plate mating surfaceApply Silicone
Marine Grade Silicone PN 8560054
2Apply marine grade silicone to pump mount assembly, Oring, and inlet scoop to pump mount mating surfaceWARNING: Do not allow silicone to enter the water inlet pipe or bilge siphon inletSevere engine damage may occur if the water inlet pipe is obstructed3Attach pump mount to hullPump Assembly Mounting Nuts 28ft.lbs(39Nm) Apply anti-seize lubricant to threadsUse criss-cross pattern when fastening4Attach inlet grate to hullLoosely thread the inlet grate mounting bolt5Apply layer of silicone to the inlet grate tab that fits into the ride plate6Attach the ride plate to the hullLoosely thread mounting bolts from from to back in crisscross patternInlet Grate Mounting Bolt: 8ft.lbs(11Nm) Apply Loctitet 242 to threads Ride Plate Mounting Bolts: 8ft.lbs(11Nm) Apply Loctitet 242 to threadsNOTE: Wipe off all excess silicone away from componentsAllow 24 hours before operating watercraft to allow silicone to cure