2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 327Get this manual
Fuel Injection System Action StepsFuel System
Step 5: Voltage Supply TestsBattery must be of adequate capacity, fully charged with clean, tight connections
ARemove 8-pin connector from rear of EMM and connect FFI
2872456
EMM Service Power Connector PN
BInstall tether cord to stop switch
CVerify fused B+(battery positive) at RedPurple wire, terminals and at the PCM (Power Control Module) pin connector (see Chapter 9, page 27)There should be more than 9.5 volts while cranking, 12 volts while runningResults: OKverify 45 volt systemGo to Step DLow voltage: Verify battery capacity, condition, and connections
DVerify 45 volt system by checking voltage with injector jumper on any injectorCheck for any of the following: Remove 8-pin co nector (PN 287 frO(ii fear of EMM and conneel.rFI