2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 208Get this manual
Final DrIvePropulsion Pump RemovalContinued
8Remove the pump extension housing, if applicableRemove the driveshaft by pulling straight outward
NOTE: Driveshaft removal is simplified with the help of an assistant pushing the drives haft outward from inside the engine compartmentTo remove the pump housing from the hull, remove the four pump housing nuts from inside the engine compartment
NOTE: Pump housing removal is only necessary when the housing requires replacement or the seal between the housing and hull has been compromisedRefer to inlet scoopride plate removal and installation section in this chapter