2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 169Get this manual
CarburetionExhaust Carburetor AssemblyContinued
Do not force screw past lightly seated or screw andor seat will be damagedOperation of the craft with mixture screws improperly adjusted (too lean) may cause serious engine damageAlways read spark plugs under actual operating conditions after assembly to verify proper mixture7Lubricate and install inlet needle, lever arm, and springTighten screw securelyInspect lever arm height outlined on page 4.33 and adjust if necessary8If any jets were removed, install the jets in the jet blockRefer to pages 4.4 to 4.6 for jet identification and locations9Install metering diaphragm, and then the gasketAlign holes in diaphragm and gasket with pins10Apply Loctite 242 to screws and install diaphragm cover with drain hole facing downwardUse care when to ensure it does not enter the using Loctite carburetor or linkages1M 1M