2001 Polaris SLH, Virage PWC Factory Service Manual, Page 240Get this manual
Electrical Systems 700cc Ignition Coils
NOTE: The ignition system used on all Polaris 700 personal watercraft engines are sequential firing typesIgnition spark on each cylinder occurs independently of the others using separate trigger pulse from each Hall Effect sensor in the statorOn models with sequential firingthe high tension leads (spark plug wires) must be installed on their respective cylinders or the engine will not run properly
To Determine Wire Sequence
1Unscrew spark plug cap from one high tension lead2Measure resistance of ignition coil secondary winding by attaching one lead of an ohmmeter to the end of the spark plug wire, and the other lead to good engine ground (see III 2for connections)Resistance should be measured with the coil at room temperatureMeasured resistance must be within 10 of 1550Q3Apply Corrosion Resistant Nyogel grease (PN 2871329) to both ends of the spark plug capScrew the cap onto wire until tight1M