2001 Polaris SLH, Virage PWC Factory Service Manual, Page 205Get this manual
HullControl Systems Steering Cable AdjustmentSLHVirageContinued
7Use main cable adjuster nuts to make major adjustmentsAdjuster nuts are located at forward end of cable near steering podOpen front compartment and remove storage tray for access to bottom nutSee III3 -,
8 Using two 1116" open end wrenches, hold one nut
and loosen the otherLengthen or shorten cable to adjust nozzle centeringTighten cable nuts securely after adjustment is complete 9Turn handlebars to left and right through entire steeri ng rangeThe bars should move freely and smoothly without binding If resistance or binding is evident check rod end positioningcable conditionand routing to locate and correct the causepost when
Use main cable nuts for major adjustments Tighten to 22ft.lbs (30Nm)I
10Remove dowell from steering adjustments are completed
Reverse Cable Adjustment
The reverse cable does not require periodic adjustmentIf the reverse linkage does not function properly, inspect the cable for damageInspect all linkage, fastenersbrackets, and pivots for wear or damageWhen new cable is installed the cable must be adjusted1o o