2001 Polaris SLH, Virage PWC Factory Service Manual, Page 140Get this manual
CarburetionExhaust Carburetor AssemblyContinued
2Install screen and new O-rings on inlet needle seatLubricate O-rings with Polaris Premium Cycle Lubricant
Polaris Premium Cycle Lubricant PN 2871098Gallon PN 2872097Quart
Install set block and tighten screw securelyInstall
4Grease low speed mixture screw O-ringsO-rings, washer, springand screw
5Turn screw in until lightly seated and then back it out the number of turns recorded during disassemblyIf number was not recorded, turn out to the specified base setting found in beginning of this chapterInstall limiter cap(s) with tab positioned midway between the stops "" o
CAUTION:
Do not force screw past lightly seated or screw andor seat will be damagedOperation of the craft with mixture screws improperly adjusted (too lean) may cause serious engine damageAlways read spark plugs under actual operating conditions after assembly to verify proper mixture6Lubricate and install inlet needle, lever arm, and spring Tighten screw securelyInspect lever arm height outlined on page 4.22 and adjust if necessary