2001 Polaris SLH, Virage PWC Factory Service Manual, Page 82Get this manual
EngineCooling Engine Disassembly 700cc EngineContinued
13Remove the two starter mounting bolts, and remove the starter
14Tap lightly on the stator housing with soft-faced hammer and remove housing"C
15Turn coupler clockwise (as viewed from rear of craft) until piston is approximately 11 (25.4mm) before Top Dead CenterNOTE: Estimate piston position using screwdriver or similar probe through plug hole16Remove screwdriver or probe and insert approximately ft(30cm of 5161 nylon rope through spark plug holeUsing coupler tool or large wrench on flats of coupler, turn crankshaft counter clockwise until rope stops the rotation of the crankshaftWith crankshaft locked in position, remove coupler by turning counter clockwise (as viewed from the rear).Do not use impact tools for coupler removalDamage may occur to the coupler or toolDo not allow rope to exit exhaut port