2001 Polaris SLH, Virage PWC Factory Service Manual, Page 57Get this manual
Maintenance HullControl SystemsContinued Adjustment ProcedureContinued
5Use main cable adjuster nuts to make major adjustments Adjuster nuts are located at forward end of cable near steering podOpen front compartment and remove storage tray for access to bottom nutSee III3Using two 1116" open end wrenches, hold one nut and loosen the otherLengthen or shorten cable to adjust nozzle centeringTighten cable nuts securely after adjustment is complete
7 Turn handlebars to left and right through entire steering rangeThe bars should move freely and smoothly without binding If resistance or binding is evident check rod end positioningcable condition, and routing to locate and correct the causeReferto chapter six steering cable troubleshooting procedures
Use main cable nuts for major adjustmentsTighten securely Torque to 22 ft .lbs(30Nm)
Reverse Cable Adjustment
The reverse cable does not require periodic adjustmentIf the reverse linkage does not function properly, inspect the cable for damageInspect all linkagefastenersbracketsand pivots for wear or damageWhen new cable is installed the cable must be adjusted1N