2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 303Get this manual
http:ReadManm
DIAGNOSTIC SOFTWARE Communication Problems
The EMM must be powered up for communication to occurThis means the battery must be charged and connectedThe stop switch lanyard must also be connectedThe Main Menu screen will be displayed when the laptop and EMM establish communication
The computer is having trouble communicating with the engine EMMPlease check the following: Tether cord is connected to stop swi tch
EMM service power connector is installed Battery connections are clean and tight
If the program locates and opens the selected com port but cannot communicate with the EMM for any reason, it will display the screen shown in illustration at rightThe software will not advance beyond this screen until communication can be established between the laptop computer and the EMMIf you see this screen, make sure the: tether cord is plugged into stop switch the FFI1M EMM Service Power Connector is installed battery cables are clean and tight battery voltage is at least 12 volts electrical connections are clean and tight circuit breaker is not tripped communication cable is attached to the laptop and to the diagnostic connector of the engine wiring harness com port number you entered, when starting or configuring the program, is connected to the communication cable