2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 291Get this manual
http:ReadManm
FFI1M FUEL INJECTION Action StepsFuel System
Step 5: Voltage Supply TestsBattery must be of adequate capacity, fully charged with clean, tight connectionsARemove 8-pin connector from rear of EMM and connect FFI 2872456BInstall tether cord to stop switch CVerify fused B+(battery positive) at RedPurple wire, terminals and at the PCM (Power Control Module) pin connector (see Chapter 9, page 27)There should be more than 9.5 volts while cranking, 12 volts while runningResults: OKverify 45 volt systemGo to Step DLow voltage: Verify battery capacity, condition, and connectionsTM
EMM Service Power Connector PN
DVerify 45 volt system by checking voltage with injector jumper on any injectorCheck for any of the following: Remove 8-pin connector from rear of EMM and connect FFI nector (PN 2872456)Tether cord connected to stop switchengine not runningCrankingapproximately 20 voltsCheck WhiteRed wire and groundEngine runningmore than 24 volts and steady at idleMore than 40 volts and steady above 3500 RPMResults: As specifiedcheck supply voltage at injectorGo to Step DAny less than specifiedtest charging system1M