2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 176Get this manual
http:ReadManm
FINAL DRIVEJET PUMPBILGE SYSTEM Intake Scoop and Ride Plate Installation
Intake Scoop Ride Plate Installation and Sealing, All Models
IMPORTANT! The area around the intake scoop and ride plate must be completely sealed in order to prevent ventilation of the pump area (cavitation)Prepare pump housing for installation before applying sealantSee VentilationCavitation page 5.30 for more informationIf ride plate or intake scoop has been removed, clean all old sealant from hull mounting areaApply 12" (1.3 cm) or larger continuous bead of marine grade silicone sealant to the area shownBe sure to apply sealant between hull and inlet scoop shown by arrowsInstall intake scoop, carefully push into placeSet ride plate in place and secure it with attaching screwsWipe off any excess sealant inside scoop area so water flow is unobstructedFor precise alignment of the scoop, install the pump housing immediately (see pump installation)IMPORTANT! Allow sealant to cure for 12 hours before operating the craft