2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 152Get this manual
http:ReadManm
ENGINE Oil Pump
Oil Pump Bleeding
The oil pump must be bled following any repair service to the injection system which might allow loss of oil and subsequent trapped air upon reassemblyIMPORTANT: Always pre-mix the first tank of fuel used after oil pump or engine service to ensure proper lubrication of the engine
70 Fill oil reservoir with Polaris injector oil71 Loosen hex head screw at top of oil pump72 After short period of time oil should begin to flow from beneath the screw headBe sure that steady flow of oil is evident to remove all air before tightening the screw73 Tighten screwBleed Screw
Do not over tightenThe screw is hollow74 Any time the engine is disassembled or repaired it is important that each oil supply line from the pump to the engine be checked for signs of wear or air bubblesIf air bubbles greater than 12" (1.3 cm) in length are present, fill oil supply lines with oil using small oil squirt can