1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 310Get this manual
ELECTRICAL Starter Motor Starter Assembly Cont6Be sure wire insulation is in place around positive brush wire and pushed completely into slot on phenolic plate7Using non-petroleum grease, lubricate brush end bushing and install shims
Align brush plate and install cover and screwsReinstall bolts and tighten evenly and securely
10Lightly grease pinion shaft and install pinion, spring stopper, and snap ring
Starter Solenoid Bench Test
To measure the resistance of the pull-in coil, connect one meter lead to the YellowRed wire and the other to groundThe resistance should be 2.8-3.6 ohmsRefer to Electric Starter System Testing in this section to further test the solenoid