1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 215Get this manual
ENGINECOOLING AssemblyPro 785 25 Inspect clamps for proper tension and concentricityReplace any clamps that are distorted (out of round) or weakBe sure the protective wrap on the line is in position at all possible wear pointsPush lines completely onto the pump and carburetor fittings, sliding clamps fully to the end past barbed portion of fitting
Air or oil leaks at the lines will cause serious engine damage26 .If carburetor intake base and studs were removed, replace gaskets and install Intake assemblyApply LoctiteTM 242 (Blue) to both ends of studs and torque studs and nuts to 78 inIbs(.9 kg-m) Use care when using Loctite to ensure it doesn't enter carbs or gum up linkages or cables 1M