1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 213Get this manual
ENGINECOOLING AssemblyPro 785 17 Install new water outlet manifold gaskets on the cylinder headsApply LoctiteTM 242 (Blue) to threads of bolts and install manifoldTorque bolts evenly to 78 inIbs(.9 kg-m)
18 Apply engine oil to oil pump drive gear, thrust washer, and bushing and install into crankcaseBe sure pump drive gear is fully engaged in crankshaft drive gear19 Apply light film of grease to new oil pump O-ring and place it in position on the pumpInstall shims removed during disassembly (if applicable) NOTE: If the oil pump, crankcase, or any of the pump drive components were replaced, the bushing end play must be measured and the proper shims installedRefer to Oil Pump Bleeding, Operation, and Troubleshooting at the end of this chapter for procedures III ::::I I: III